Community > Article > Detail RETURN

Problems Needing Attention in the Use of Extra Length Overnight Sanitary Napkin Machine

Maintaining the stable and orderly operation of the electrical system of extra length overnight sanitary napkin machine is the basis and premise for the efficient operation of mechanical manufacturing. In order to effectively reduce the failure rate of electrical system, it is very important to do a good job of daily maintenance. In actual production, the maintenance of extra length overnight sanitary napkin equipment electrical system is mainly through the wear and damage of maintenance parts.

 

 

1.Usage environment of extra length overnight sanitary napkin machine

In order to improve the service life of extra length overnight sanitary napkin machine, it is generally necessary to avoid direct sunlight and other thermal radiation, and avoid places with moisture, dust or corrosive gases. Precision machinery and equipment should be far away from equipment with large vibration. In order to avoid the influence of large power fluctuation (more than ± 10%) and possible instantaneous interference signal, special line power supply is generally adopted for machinery and equipment (such as the machine is used separately from the low-voltage distribution room) or voltage stabilizing device is added to reduce the influence of power supply quality and electrical interference.

 

2.Improve the quality of operators of extra length overnight sanitary napkin machine

The use of extra length overnight sanitary napkin machine is more difficult than ordinary equipment, because the machine is a typical mechatronics product, involving a wider range of knowledge, that is, the operator should have a wider range of professional knowledge of mechatronics, liquid, gas and so on; In addition, due to the rapid upgrading of the gas control system, if you do not regularly participate in professional theoretical training, you can not master the new system application, and the quality requirements for operators are very high. Therefore, in order to systematically learn the principle, performance, lubricating parts and operation mode of the equipment, the machine operators must be trained to lay the foundation for better use of the equipment. At the same time, in the use and management of the machine, a series of maintenance and use measures have been formulated.

 

3.Formulate operating procedures for extra length overnight sanitary napkin machine

In terms of use and management, a series of practical operating procedures should be formulated. For example, lubrication, maintenance, rational use and standardized handover system are the main contents of the use and management of machinery and equipment. Formulating and abiding by operating procedures is one of the important measures to ensure the safe operation of the machine. Practice has proved that following the operating procedures can reduce many faults.

 

4.Usage failure of extra length overnight sanitary napkin machine

Treat the extra length overnight sanitary napkin machine faults calmly, and do not deal with them blindly. Some failures will inevitably occur in the use of the equipment. At this time, the operator should treat calmly and do not deal with it blindly, so as to avoid more serious consequences. Pay attention to keep the site, and the maintenance personnel shall truthfully explain the fault before and after, participate in joint analysis and eliminate the fault as soon as possible. If the fault is caused by operation, the operator shall learn experience in time to avoid making the same mistake next time.

 

After purchasing extra length overnight sanitary napkin machine, you should make full use of it. The newly purchased machine should be put into use as soon as possible. The initial failure rate of equipment is often large. Users should make full use of the equipment during the warranty period, expose its weak links as soon as possible and solve them within the warranty period. In order to reduce the wear of clutch, gear and other equipment, the opening and closing of the machine spindle shall be reduced as much as possible in the processing process.

Comment(0)

You can comment after

SIGN IN

Author

Elliott

Articles

5

Views

346

Supports

0

0

0